Danby Portable Air Conditioner

I just bought a Danby 12,000 BTU, Model DPAC120068. I have 2 problems / things I can not understand.

1. It does not matter what I put on, it stops. I have the temperature set to 75 degrees, and woke up this morning to a room 67 degrees. Why not turn it off?

2. I have both the intake and exhaust hanging from my window, and the humidity is 70% off, 46% in my room. I leave the dehumidifier running good for 6 hours, and there is still no water in the external tank. The room does not feel wet, but where is the water going? It does not flow to the exhaust, and there is no water on my floor.

Ideas? Please?

I hear they are not expelling water. They may be a way internally of it evaporates like a refrigerator. As it does not cut ... it is not fair. Have you looked in your manual? It could be defective. The thermostat might not work. In addition, make sure the device is not in direct sunlight. Finally, have you called the customer support number? They should be able to help you understand what's wrong.

BTW, it's like this? He says there is no water to empty ...

http://www.overstockdeals.com/Fedders_Ai ...

I had a portable AC for years, and never more than a trickle on the tank at the end of the season. The condensed water from the evaporator and condenser is suspended evaporates at the hot air outside the exhaust pipe as steam.

Regarding why he did not cut with the thermostat, do you put on the AC? If it was on the dehumidifier part, it may have been detecting moisture in the pipes and trying to dehumidify the great outdoors. Have you read all the instructions?

I think about putting it in AC has to cool a few degrees below the setpoint before the compressor stops, but the fan is always likely.